Simple Radio Control Receiver Using HT

1. RWS Gnd to header-pin #1
2. RWS Vcc to header-pin #3
3. RWS Digital-Output to header-pin #2

HT-12E encoder data transfers to HT-12D data-pins via RF transmission.
VT-pin transitions from low to high on valid reception & address.
More detailed information is available from http://www.rentron.com
For 8-bit RF remote control, substitute the HT-12D with HT-648L decoder.

Related posts:

1. Radio Control Using MC-145026 & MC-145027 The nine lines may be encoded with trinary data (low, high, or open) or binary data (low or high). If binary data is used at the encoder, 32 addresses are...
2. 8 Bit Data And 10 Bit Adrress Radio Control This Decoder give 8 Bit Data and 10 Bit Address....
3. Simple Radio Control Transmitter Using HT Using IC HT12-E we can Create R/C Transmitter very Easy This IC have 8 Bit address....
4. Radio Control Using DTMF This Schematic using IC UM91214B for transmitter and using IC KT3170/8870 for Receiver, this IC usually use for telephone to generate DTMF tone....
5. Remote Control IR Transmitter Receiver Infrared Transmitter and Receiver schematic diagrams Pyroelectric Infrared Sensor Minimal Infrared transmitter for PC Simple IR transmitter circuit Simple infra-red detector Infra Red Switch IR remote control extender IR Remote...
6. Radio Rf Receiver Fm Transmitter Amplifier Schematics Control Interface Level Converter Schematics wiring diagram circuits schema electronic projects One transistor FM receiver Schematics wiring diagram circuits schema electronic projects Op-Amp Radio Schematics wiring diagram circuits schema electronic...

Related posts brought to you by Yet Another Related Posts Plugin.

del.icio.us Digg it Furl iFeedReaders ma.gnolia Maple.nu Netscape reddit Spurl StumbleUpon Wink Yahoo MyWeb

This entry was posted on Thursday, October 11th, 2007 at 3:29 pm and is filed under Frequency, Radio Control Application, Remote Control, Schematics, Sound/Radio Circuits. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.