Radio Control Switch

This is A Simple RC switch Using IC 4001 and Transistor BC547.

Related posts:

1. Basic Radio Control Encoder Note that normal joysticks used for computers may be fitted with a linear 100K pot but provide only 60 degrees of the total 300 degrees of movement. The 4017 outputs...
2. Radio Control Using DTMF This Schematic using IC UM91214B for transmitter and using IC KT3170/8870 for Receiver, this IC usually use for telephone to generate DTMF tone....
3. 8 Bit Data And 10 Bit Adrress Radio Control This Decoder give 8 Bit Data and 10 Bit Address....
4. Basic Radio Control Decoder If the output of the receiver is capacitively coupled, has a standing negative DC potential or is DC grounded then couple the signal in via a 10nF capacitor and connect...
5. Simple Radio Control Receiver Using HT RWS Gnd to header-pin #1 2. RWS Vcc to header-pin #3 3. RWS Digital-Output to header-pin #2 HT-12E encoder data transfers to HT-12D data-pins via RF transmission....
6. Simple Radio Control Transmitter Using HT Using IC HT12-E we can Create R/C Transmitter very Easy This IC have 8 Bit address....

Related posts brought to you by Yet Another Related Posts Plugin.

del.icio.us Digg it Furl iFeedReaders ma.gnolia Maple.nu Netscape reddit Spurl StumbleUpon Wink Yahoo MyWeb

This entry was posted on Thursday, October 11th, 2007 at 3:10 pm and is filed under Radio Control Application, Remote Control, Schematics, Sound/Radio Circuits. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.