Power Amplifier Circuit with 2n3055. Simple and low cost power amplifier. The optimal accumulation voltage is about 50V, but this amp assignment from 30 to 60V. The acute ascribe voltage is about 0.8 – 1V. As you can see, in this architecture the apparatus accept a big tolerance, so you can body it about of the components, which you acquisition at home. The and transistors can be any NPN blazon ability transistor, but do not use Darlington types. The achievement ability is about 60W.

Descriptions: Read the rest of this entry »

Incoming search terms for the article:

Here is another mini circuit project. This is a Mini Amplifier that have a simple tone control. Here is the Scheamatics

Mini Amplifier

You can comment here if get something wrong with this electronic schematic design

Incoming search terms for the article:

Here is a two-transistor Wien bridge oscillator using an ordinary night-light bulb for stabilization. The output is about 6 volts p-p and can drive fixed loads as low as 2 or 3 thousand ohms without additional buffering. A 10 k amplitude potentiometer with the wiper going to a high input impedance output amplifier would make an excellent load.

Excellent distortion is achieved by adjusting the 1 k feedback potentiometer until the output amplitude is about a volt less than the maximum level (with the pot set to the highest resistance). Wait a few seconds between adjustments to give the bulb time to stabilize; the audio signal actually heats the bulb’s filament causing the resistance to go up which controls the loop gain. You will see the signal bounce a little as the bulb gains control. This simple version of the popular Wien bridge oscillator uses feedback to hold the junction of the two RC networks (base of first transistor) near zero volts (100 mV p-p) and the ends of the RC networks move in opposite directions like a see-saw.

Read the rest of this entry »

Incoming search terms for the article:

Here is a phase-shift audio oscillator with excellent distortion characteristics thanks to “softened” diode limiting provided by the 1N914 and resistor divider and degenerated gain provided by the 68 ohm emitter resistor. For minimum distortion, increase the 68 ohm resistor to a point just below where oscillation stops. A simple buffer may be added for driving lower impedance loads. The output amplitude will be about 5 volts p-p but one of the 1N914’s 10k divider resistors may be changed for a different output amplitude.

The circuit will work well with a power supply voltage other than 9 volts but the 68 ohm resistor may need adjustment

Incoming search terms for the article: