Basic Stamp Interface Control Programming
Basic Stamp Computer Eases Prototyping hassles: 04/09/98 EDN-Design Ideas Basic Stamp Interface Circuits: Basic Stamp Lightning Activity Monitor: ...
Basic Stamp Computer Eases Prototyping hassles: 04/09/98 EDN-Design Ideas
Basic Stamp Interface Circuits:
Basic Stamp Lightning Activity Monitor:
BASIC Stamp Thermoelectric Cooler:
Build a PIC Controlled DDS VFO, 0 to 6 MHz:
C 52 EVB Robot Controller:
Circuit Controls Two LEDs With One Microcontroller Port Pin : 04/01/02 Electronic Design – Ideas for Design /Microcontroller port pins can typically be driven either high or low, or else be put into an “input” or high-impedance state. This circuit uses the three states to drive two separate LEDs with one port pin. This can be very useful when there are no…
Circuit provides watchdog for microcontrollers: 12/26/2002 EDN – Design Ideas / The watchdog circuit in Figure 1 uses a single NAND Schmitt-trigger IC. The circuit is more cost-effective than dedicated, commercially available watchdog ICs. The circuit generates an active-high reset signal upon power-up and remains in a low state as long as the control input receives pulses. Whenever the pulsing at the control input stops, whether the circuit is in a high or a low state, th….
Closed Caption Decoder: This is a closed-caption decoder with serial output, based on a PIC16C71, an Élantec EL4581C sync separator, and an LM393 dual comparator (for data slicing with automatic threshold).
Combination Lock (PIC16F84):
Connecting LED to PIC Micro I/O Pins:
Connecting PIC12C508 8 to 93AA46 Serial Eprom:
Controller Provides Multiple Alarm Driver Formats: 01/15/98 EDN-Design Ideas
Incoming search terms for the article:
basic stamp icons,basic interface circuits,basic stamp alarm security programming,basic stamp remote control,basic stamp serrial interface,No related posts.
Related posts brought to you by Yet Another Related Posts Plugin.
Stumble It!
